This is a prototype of a Preset Counter. It is built with ICM7217. The cabinet is ABS Plastic DIN 96-96. The Panel is Engraved on Acrylic.

I don't remember for which application it was used. It has three thumbwheel settings, when the proximity switch counts upto the set-value, the corresponding relay turns ON, with a State Indicating LED on front panel.

These can be configured sequentially or to work synchronously, this depends on what customer wants. Both modes may give the same result. In sequential operation, Some of these counters-timers may need to wait for an external trigger or feedback from a limit switch or another process like pressure alarm. Then more Input options may have to be provided.

Basic Electronic Digital Circuits

Counters, timers, analog-process and its interconnectivity makes up the various process loops or chain-reactions in Machine control. The various types of sensors for measurement and feedback of analog and event parameters, monitor the mechanical system and communicate the data to the process instruments.

 

 

The below circuit is a reference, i used the old intersil hot ideas book. There was no internet then. Databooks were valuable reference material. In the below timer circuit replace the clock with a schmitt trigger signal conditioning, it becomes a event counter or preset counter with thumbwheel input. See photograph above.

The Actuators like Drives, Solenoids, Pumps, Valves and Heaters act in accordance to the commands of the control system. This regulates and manages the process or machine to deliver consistent and repeatable yield of the end product.